CA2001 problem
CA2001 problem
I have a CA-2001 which worked nice. Today, however, when turned on, the engine fires, the head flies to track 39 and the engine stops. The listing attempt ends with device not respond.
I'm settling new lands
CA2001 problem
point 0: check the connection of the SIO cable. Point 1: check on a different Atari. It doesn't have to be the station's fault.
WE all are OLD.
- Oldlegends
- Posts: 30
- Joined: Fri Sep 24, 2021 12:58 pm
- Location: storybook
- Yellohello
- Posts: 28
- Joined: Fri Sep 24, 2021 12:44 pm
- Location: Happy place of dreams
CA2001 problem
But the station starts normally? I mean, on track 0, it turns the engine, and after some time on 39 and stop? Have you checked the second SIO slot? Didn't your station number change to any other than 1?
Hello there all.
- NamelessOne
- Posts: 27
- Joined: Fri Sep 24, 2021 11:58 am
- Location: The nameless city under earth
CA2001 problem
This is exactly what is happening
is track 0, the motor starts spinning, goes to track 39 and the motor stops
when I release the pressure and close it again, nothing happens - the engine is stopped and the head is still at 39
I also checked the second SIO port, I did not change the numbering. Yesterday it was working - today elo
I have no name and never will have.
CA2001 problem
Next in the diagram is the U7 buffer.
CA2001 problem
Well, the cables checked, plugs, dip switch too. I think I will mention this U7. Earlier, I also connected the stations to the fujinet grommet and the tape recorder to the station
I'm a great warrior of old lore.