Page 1 of 2
CA2001 problem
Posted: Sat Oct 09, 2021 8:23 am
by TerraNova
I have a CA-2001 which worked nice. Today, however, when turned on, the engine fires, the head flies to track 39 and the engine stops. The listing attempt ends with device not respond.
CA2001 problem
Posted: Sat Oct 09, 2021 8:31 am
by Oldgirls
point 0: check the connection of the SIO cable. Point 1: check on a different Atari. It doesn't have to be the station's fault.
CA2001 problem
Posted: Sat Oct 09, 2021 9:06 am
by Oldlegends
I checked two cables and two computers - to no avail
CA2001 problem
Posted: Sat Oct 09, 2021 10:46 am
by Yellohello
But the station starts normally? I mean, on track 0, it turns the engine, and after some time on 39 and stop? Have you checked the second SIO slot? Didn't your station number change to any other than 1?
CA2001 problem
Posted: Sat Oct 09, 2021 11:17 am
by NamelessOne
This is exactly what is happening
is track 0, the motor starts spinning, goes to track 39 and the motor stops
when I release the pressure and close it again, nothing happens - the engine is stopped and the head is still at 39
I also checked the second SIO port, I did not change the numbering. Yesterday it was working - today elo
CA2001 problem
Posted: Sat Oct 09, 2021 12:52 pm
by ThatGuy02
Next in the diagram is the U7 buffer.
CA2001 problem
Posted: Sat Oct 09, 2021 2:11 pm
by Wariorr
Well, the cables checked, plugs, dip switch too. I think I will mention this U7. Earlier, I also connected the stations to the fujinet grommet and the tape recorder to the station
CA2001 problem
Posted: Sat Oct 09, 2021 3:45 pm
by Iwa
But are you testing without FN?
CA2001 problem
Posted: Sat Oct 09, 2021 5:00 pm
by PanzerGeneral
Yes, no - Atari goals
CA2001 problem
Posted: Sat Oct 09, 2021 5:19 pm
by ThisGuy01
replacing U7 helped <3