I broke my 600XL
- Oldlegends
- Posts: 30
- Joined: Fri Sep 24, 2021 12:58 pm
- Location: storybook
I broke my 600XL
Sure, I can put it on, but Blouses asked if I took it out I have to buy it, because I don't have 180pf.
Legend of old are still alive.
I broke my 600XL
Re-inserting the 180pf capacitor worsened image quality, but did not change the behavior of the computer.
I'm settling new lands
I broke my 600XL
Well, the electronics-atheist will have to look at the equipment.
I'm from Poland in Euro.
I broke my 600XL
And you can answer how to look for a potentiometer (the color one) to replace it? I do not know how to search for such a shape.
This is my little place of internet.
- PanzerGeneral
- Posts: 37
- Joined: Wed Oct 14, 2020 7:10 am
I broke my 600XL
Mounting potentiometer, horizontal, 470 - 500 k ohms, linear. The raster of the pins (spacing of the pins / holes in the PCB) is important. It will probably be 5x10 mm. For example: c
I broke my 600XL
Don't touch that potentiometer, it's good. You have a problem with the transistor, you probably did not install it. The reverse soldered transistor should not break down, because it works at 5V, which is lower than the base-emitter zener voltage.
This transistor is designed to amplify the fi1 signal, and feed it to the voltage doubler on C40, CR1, CR2 and C41. The voltage increased in this way, after smoothing in the R42 C42 filter, is given to the potentiometer, which sets the correct voltage on the GTIA pin17.
If the voltage on this pin changes from 0 to 7 ~ 9V while rotating the slider, that's OK. If not - check the transistor. What is the transistor model?
WE all are OLD.
- Catladyiscrazy
- Posts: 32
- Joined: Fri Sep 24, 2021 11:31 am
- Location: Kitty Litter
I broke my 600XL
If you are talking about Q6 it is 3409, the same as it was on the board originally. As I wrote before, I put in this item a total of two items 3409, once the other way around, and then another item correctly. The voltage changes from 0 to 9V on the potentiometer as it turns.
Nothing here for now...
I broke my 600XL
I'm afraid that @jer could have been Q1 rather ... And from what he wrote it is rather nothing to him. Probably also the potentiometer.
- SummerFLower
- Posts: 29
- Joined: Fri Sep 24, 2021 12:29 pm
- Location: Summer land of joy and warm
I broke my 600XL
The oscilloscope, as I understand it, you don't have, because you would have used it already. But if you have a multimeter, you can at least check the circuit statically. Before that, turn off the color (POKE 710,0: POKE709,0) because it will distort the measurement. The voltages should be similar to those shown in Jere's diagram.
i just strartedt to bloon this summer.
- MovieDirector@
- Posts: 28
- Joined: Fri Sep 24, 2021 12:22 pm
- Location: Movie set
I broke my 600XL
Has it been repaired? I am also wondering to remove (cut one leg) the C109 in my 600xl.
I'm gonna direct a movie someday...